GORE Air vent and base

CLICK HERE TO DOWNLOAD THE INSTALLATION AND USE INSTRUCTIONS

GORE™ Protective Vents + Shapers custom Base: for easy installation.

No more taping the surfboard, just rout out a hole and drop in the base that is pre-tapped for your convenience.

GORE™ Protective Vents allows EPS Core Surfboards to pass air back and forth between the core and the exterior of the board while preventing water from entering. This is due because EPS surfboard materials are affected by extreme temperature changes. There is a double membrane of “Gore-Tex” either side of a rubber O-ring. This membrane is waterproof this allows the vent to works by allowing air and other gases to pass through the membrane freely but stops liquids from entering the enclosure. The Gore-Tex membrane does not require any adjustment. Please note: Vents are black.

The Diameter of the base member is 32mm, we would recommend to drill a 34-36mm hole to ensure there is efficient amount of resin around to base

What is .... Gore Protective Vents for Surfboards and Watercrafts, Gore membrane vents allow the pass of air and other gases both ways while blocking the flow of liquid water. The technology behind the vent's breathability lies in our ePTFE materials. Gore microporous ePTFE membrane prevents pressure build up by constantly equalizing the difference in pressure between the inside of the enclosure and its immediate environment. This constant exchange reduces the pressure on the seals. The vent works by allowing air and other gases to pass through the membrane freely but stops liquids from entering the enclosure. The membrane offers varying flow rates and liquid protection. The industry standard for epoxy Surfcraft that utilised expanded polystyrene foam or hollow boards such as timber surfboards.